What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Problem setting up SNMP for monitoring a BCM 450

Votes:

0

I am trying to setup monitoring of our BCM 450 PBX. It is running Linux OS. The Auto discovery found ping, http, IMAP and 2 LANs. When I try and add a sensor for CPU usage (or anything else) using v1 SNMP it gives an error saying "No Such Name (SNMP error # 2)" I have made certain that the PRTG server ip-address is allowed to connect to BCM and have made sure that the Community strings on PRTG server and BCM are the same. I have tried using v1 and v2c SNMP versions, but get the same error message. I have done an SNMPWalk fron the PRTG server and I see OIDs returned.

bcm prtg snmp

Created on Nov 13, 2014 6:09:57 PM



1 Reply

Votes:

0

Hello,

Please use the SNMP Tester on the Probe Device and do an SNMP walk on the OID 1.3.6.1 Please forward the zipped results to [email protected] and refer to this knowledge base article.

Best regards

Created on Nov 14, 2014 1:08:33 PM by Felix Saure [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.