After I run auto discover for my juniper firewall, seems only configured interface are shown. I would like to know is it normal? And any way can add all interfaces?
Created on Nov 28, 2014 2:11:39 AM by
1 Reply
Dear Jimmy,
The auto-discovery adds traffic sensors for interfaces which haven't been added before and where the traffic is not null. If you want to add additional interfaces, you can add an SNMP Traffic Sensor and choose the interfaces manually.
Best regards
Created on Dec 1, 2014 1:29:15 PM by
Please log in or register to enter your reply.
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment