What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Multiple scanning intervals

Votes:

0

Is there an easy way to set up the scanning interval at the sensor type? For example, I would like to check CPU utilization every 60 seconds and check disk usage every 30 minutes. Rather than going through every device and setting the intervals for each sensor, I'd rather change it at a top level sensor type and have it apply to all devices.

prtg scan-interval scanning-interval

Created on Jan 14, 2015 12:49:37 AM



1 Reply

Accepted Answer

Votes:

7

The easiest way is: Choose on the top Sensors -> by Type -> choose your Sensor type (for example Windows CPU Load) All your Windows CPU Load Sensors will be shown now. Click select all and then click on settings (at the top on the right) Now you can change some settings for all of these Sensors like the interval.

Regards Birk Guttmann

Created on Jan 14, 2015 8:33:45 AM




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.