What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

PRTG v15 layout change?

Votes:

0

Your Vote:

Up

Down

I recently updated PRTG from v14 to v15.1.15.2022 and have now found that the device and sensor layout has changed.

Previously under v14 when you went into a device/sensor, it would have the status bar along the top, any 4/5-star priority balloons underneath that and finally the sensor-list or channel information underneath that.

After the v15 update, the status bar is still along the top, however the 4/5-star priority balloons and sensor-list/channel info (and the new similar/suggested sensor section) is side-by-side. This causes the page to be difficult to read when you have a few of the priority balloons selected.

Is this a known issue, or is there a simple fix?

Cheers!

layout prtg prtg15

Created on Apr 21, 2015 1:38:39 AM by  cimrak (20) 1



1 Reply

Votes:

0

Your Vote:

Up

Down

Hi there,

Could you forward some screenshots to [email protected] to visualize the exact issue? Please refer to this Knowledge Base article.

Best regards

Created on Apr 22, 2015 1:13:02 PM by  Felix Saure [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.