How do i set alarm if a process hang? I can set alarm if the process is not running but if the process or the application hang PRTG still consider it as uptime state.
Last change on Jul 9, 2010 12:30:43 PM by
Monitor hanging process
Votes:
0
1 Reply
Accepted Answer
Votes:
0
Hello,
I'm very much afraid PRTG is not able to determine if a monitored Process hangs or runs properly. There might be hints (high CPU load of the process), which you could use for a threshold trigger, or an error-limit, but as said this would be only a 'hint' no proof.
Best Regards.
Created on Jul 6, 2010 2:29:18 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment