Can I disable the &#34;Unusual&#34; alert on a specific sensor?

We found "unusual" alert is useful for detecting the pattern of sensor.

However, some sensors are really no special pattern and we want to disable to detect the "unusual" alert on it individually and reduce the fault alarm.

Anyone can give some hints on it?

Thank you very much!

sensor setup unusual

Created on May 14, 2015 7:39:12 AM by Daniel (0) ●1

6 Replies

Votes:

0

Your Vote:

Hi Daniel,

This can only be turned on/off system wide. You could only remove the unusual notification. If it's inherited, turn off inheritance by switching to Only use the triggers defined below. Note that this doesn't work with library defined notifications as they're always executed.

Best, Stephan

Created on May 14, 2015 10:13:43 AM by Stephan Linke [Paessler Support]

Votes:

0

Your Vote:

Hi Stephan,

Actually "unusual" is a good design but we need not apply to all sensors and it maybe make mush noise. Anyway thanks for your reply.

Thanks. Daniel

Created on May 22, 2015 1:36:26 AM by Daniel (0) ●1

Votes:

0

Your Vote:

Hello,

since this article was last updated in 2015, is there a change in the possibility to exclude certain sensors / sensor types?

Thanks Jacqueline

Created on Oct 17, 2017 6:42:12 AM by Jacqueline Weigel (26) ●2

Votes:

0

Your Vote:

Hi Jacqueline,

In the meantime, it can be disabled on the device/group level, at the very bottom of the settings tab. Simply untick "Advanced Network Analysis" and it will appear.

Kind regards,
Stephan Linke, Tech Support Team

Created on Oct 17, 2017 1:57:43 PM by Stephan Linke [Paessler Support]

Votes:

0

Your Vote:

Hi Stephan,

Thank you for your help, i found the setting :).

Created on Oct 17, 2017 2:42:04 PM by Jacqueline Weigel (26) ●2

Votes:

0

Your Vote:

You're welcome! :)

Kind regards,
Stephan Linke, Tech Support Team

Created on Oct 18, 2017 6:27:59 AM by Stephan Linke [Paessler Support]