What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Configure PRTG to Monitor Cisco Switch

Votes:

0

Your Vote:

Up

Down

Hello, I want to configure PRTG to monitor our cisco switches 3560 and 3750 series in the network like alerts if trunk goes up/down, if switch goes offline. CPU and memory and bandwidth.

Thanks in Advance.

cisco-3560 cisco-3750 prtg snmp-trap

Created on May 27, 2015 8:12:52 PM by  samirshk88 (0) 1



1 Reply

Votes:

0

Your Vote:

Up

Down

Dear Samirshk

Please add those switches as devices in PRTG. If you want to add sensors manually, please use the according button and type "Cisco" to filter only for Cisco sensors, like the System Health sensor.

As an alternative, you can perform an auto-discovery on the device and when it is completed, delete all sensors which you don't want to use.

Created on May 29, 2015 11:30:52 AM by  Arne Seifert [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.