Hello, Can someone tell me correct way to monitor the number of computers connecting to a Cisco 1140 WAP?
Monitor # of connections to a Cisco 1140 WAP
Votes:
0
1 Reply
Votes:
0
The value of the current active connections should be stored in a sub OID of
1.3.6.1.4.1.9.9.273.1.1.2
Use our SNMP Tester to do a walk on that OID to determine the correct OID holding the active users. Back in PRTG, use a SNMP Custom sensor to monitor that specific OID :)
Created on Jun 5, 2015 12:07:09 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment