What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

SNMP system uptime Cisco ASA

Votes:

0

Hello,

I would like to monitor a Cisco ASA for uptime.

However when I try to use a normal Cisco sensor it is not working. I'm using the correct community string, version and port.

The Cisco ASA is not receiving the SNMP request on the outbound ports.

cisco prtg snmp

Created on Jul 9, 2015 2:23:54 PM



3 Replies

Votes:

0

Dear user

Please use the SNMP Tester to connect to your Cisco device outside of PRTG. Please enter the proper address, SNMP version, and community string. Can you successfully read the Uptime with that tool?

Created on Jul 10, 2015 12:33:12 PM by Arne Seifert [Paessler Support]



Votes:

0

Hello,

I used the tool, I get the following back:

13-7-2015 11:45:27 (117 ms) : Device: xx.220.91.26
13-7-2015 11:45:27 (117 ms) : SNMP V2c
13-7-2015 11:45:27 (118 ms) : Uptime
13-7-2015 11:45:29 (2198 ms) : -------
13-7-2015 11:45:29 (2199 ms) : DISMAN-EVENT-MIB::sysUpTimeInstance = No response (check: firewalls, routing, snmp settings of device, IPs, SNMP version, community, passwords etc) (SNMP error # -2003) ( 0 seconds )
13-7-2015 11:45:31 (4211 ms) : HOST-RESOURCES-MIB::hrSystemUptime.0 = No response (check: firewalls, routing, snmp settings of device, IPs, SNMP version, community, passwords etc) (SNMP error # -2003) ( 0 seconds )
13-7-2015 11:45:31 (4212 ms) : Done

Please advise

Created on Jul 13, 2015 9:47:12 AM

Last change on Nov 4, 2015 3:29:26 PM by Luciano Lingnau [Paessler]



Votes:

0

Dear user

This message means that with the address and credentials provided, an SNMP connection cannot be established. Please double check if you use the right IP and port, and if the SNMP version and community string is correct.

Created on Jul 13, 2015 11:22:17 AM by Arne Seifert [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.