What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

How do I set alarm and warning thresholds on the SSH Load Average sensor?

Votes:

0

I would like to set alarm and warning thresholds on the SSH Load Average and SSH Load Average v2 sensors, but I can not find any place in the sensor or channel settings to effect that.

Where do I make that change?

alarm cpu-load limits notifications ssh threshold

Created on Jul 24, 2015 9:07:01 PM

Last change on Nov 14, 2024 8:57:37 AM by Jacqueline Conforti [Paessler Support]



1 Reply

Votes:

0

Hello Josiah, thank you for your contact.

Please check the Sensor's Channels Settings, there you can Enable Limits and then Configure one or more of the following:

  • Upper Error Limit
  • Upper Warning Limit
  • Lower Warning Limit
  • Lower Error Limit

After you've set-them-up, you can configure State Triggers to send notifications for Warning or Error statuses.

Created on Jul 27, 2015 12:01:05 PM by Luciano Lingnau [Paessler]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.