What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

how to purge specific entry from bandwidth log.

Votes:

0

Hi All,

We are using free version of PRTG.

Since yesterday bandwidth graphs are incorrect. Scale has reached up to 3 Gbps. Up on verification I found incorrect entry which is

8/15/2015 5:30:00 PM - 6:30:00 PM 1,371,613,962 KByte 3,147,659 kbit/s 1,370,858,341 KByte 3,145,925 kbit/s 755,621 KByte 1,734 kbit/s 0 % 99 %

If I deselect total traffic and in traffic (Of this spike), I can see regular graph.

how can I delete this specific entry?

bandwidth purge sensor-data

Created on Aug 18, 2015 5:58:03 AM



Best Answer

Accepted Answer

Votes:

0

Pardon, I meant the spike filter - when you click the small gear within the channel panel, it's in the lower half. You can also set upper and lower limit values for that. Please have a look at the manual: https://www.paessler.com/manuals/prtg/sensor_channels_settings.htm

It's under "Spike Filter" on that page :)

Created on Aug 18, 2015 7:45:07 AM by Stephan Linke [Paessler Support]



5 Replies

Votes:

0

You can enable the spike filter in the channel settings - the high values will be discarded then.

Created on Aug 18, 2015 7:33:08 AM by Stephan Linke [Paessler Support]

Last change on Aug 18, 2015 7:42:51 AM by Stephan Linke [Paessler Support]



Votes:

0

Could you please guide me on the steps..

Created on Aug 18, 2015 7:35:09 AM



Accepted Answer

Votes:

0

Pardon, I meant the spike filter - when you click the small gear within the channel panel, it's in the lower half. You can also set upper and lower limit values for that. Please have a look at the manual: https://www.paessler.com/manuals/prtg/sensor_channels_settings.htm

It's under "Spike Filter" on that page :)

Created on Aug 18, 2015 7:45:07 AM by Stephan Linke [Paessler Support]



Votes:

0

Thanks that fixed it.

I also added maximum "vertical access scaling" value and everything is working fine.

Thanks....

Created on Aug 18, 2015 8:35:19 AM



Votes:

0

You're welcome :)

Created on Aug 18, 2015 8:50:15 AM by Stephan Linke [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.