What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

PRTG Meraki integration using Netflow, hardware recommendation

Votes:

0

Have a customer, currently 5 sites (MX firewall and MR WAP), they are happy with features on Meraki Dashboard, but the data lapses after 30 days. They would like to have data available for 3 years in the past. They want following info:

  1. How many users connected to the WiFi across all sites, and on individual sites
  2. Top websites
  3. How much data have they used (each user and a site).

The solution needs to accommodate 15 new sites in near future (total of 21), while prospect is to get total of 300 like sites monitored the same way.

  • How do I do it with Netflow?
  • Roughly, what hardware configuration might be OK for PRTG to run on it exclusively?
  • Expanding from 21 to 300 sites is preferred through adding disk(s) with higher capacity

Please advise or give some directions...

Thanks

meraki prtg syslog

Created on Apr 2, 2016 1:52:27 AM

Last change on Apr 4, 2016 7:48:22 AM by Felix Saure [Paessler Support]



1 Reply

Votes:

0

You may want to use the SNMP OID Table sensor for the wifi users (it may or may not work). What type of sensors and how many would you like to use on each site?

Created on Apr 5, 2016 2:04:13 PM by Stephan Linke [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.