What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Getting warning below

Votes:

0

Monitoring may be incomplete or inaccurate due to fundamental problems in your PRTG installation! Click here for more information!

397 % Delay (Interval Delay WMI) is above the error limit of 100 % Delay in Interval Delay WMI. WMI Sensors of this probe can not be scanned in their specified intervals. Try longer intervals or distribute load over probes. - 440 % Delay (Interval Delay non-WMI&SNMP) is above the error limit of 100 % Delay in Interval Delay non-WMI&SNMP. Sensors of this probe can not be scanned in their specified intervals. Try longer intervals or distribute load over probes.

probe setup wmi

Created on Jun 20, 2016 4:01:30 PM



3 Replies

Votes:

0

Hello,

We will need to have a look in the log files to investigate this issue. Could you please forward a support bundle Setup > Contact Support and refer to this knowledge base article?

Created on Jun 22, 2016 1:12:16 PM by [email protected]



Votes:

0

Hi,

Am getting similar kind of error after upgrading PRTG to version 17, can someone help on this.

Created on Dec 19, 2017 1:58:34 PM



Votes:

0

Hi there,

Please proceed as Jochen wrote. Without any further log files and information about your system we are unable to troubleshoot this.

Best regards.

Created on Dec 19, 2017 7:05:51 PM by Dariusz Gorka [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.