What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

SMNP Traps Sensor goes Back to up

Votes:

0

Hi there

I have installed SNMP Trap. Everything works fine. My Network devices sends a snmp trap every minute. So in PRTG i will check the Sensor every minute. So as soon as the first traps arrive the sensors changes to red. That's ok and how it should be. But within 2 or 3 minutes the sensor turns green again even if my network devices is continuing sending snmp traps. Did i miss on setting?

sensor snmp traps

Created on Aug 16, 2016 1:46:04 PM



1 Reply

Votes:

0

Hello,

Could you please forward us some screenshots showing the "Overview", "Log", "Settings"and "notifications" tab of the sensor in case to [email protected]? Please refer to this kb post.

Created on Aug 17, 2016 12:28:00 PM by [email protected]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.