Hello,
Can I set a sensor run at a fixed time everyday not a fixed interval? Like 5:00 AM everyday.
Thanks you.
1 Reply
Accepted Answer
This can be done by adding a new interval under <your-prtg>/systemsetup.htm?tabid=2 in the "Scanning Interval" section. Simply add the following line:
@ UTC hh:mm
If you need multiple execution times, comma separate them:
@ UTC hh:mm, hh:mm,
Note that time time is always in UTC, so make sure to enter the time accordingly.
Created on Aug 25, 2016 7:13:35 AM by
Last change on Aug 25, 2016 7:13:48 AM by
Please log in or register to enter your reply.
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment