Login

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Would it be best to monitor Cisco device through primary network port or CIMC port?

Votes:

0

When I try to add an SNMP Cisco sensor to PRTG to monitor UCS or Cisco Integrated Management Controller it fails and throws back an error 2003. Can you list the most common errors with Cisco UCS sensors and provide possible reasons and solutions?

Would it be best to monitor Cisco device through primary network port or CIMC port?

cisco prtg snmp

Created on Aug 25, 2016 4:22:14 PM

1 Reply

Votes:

0

Dear tyrosales

Error -2003 usually means that no SNMP connection could be created using the address, port and string setting provided. Please try to connect with SNMP outside of PRTG using our SNMP Tester. Please enter the according address and connection settings and try to read the device uptime.

Are you getting a result, or a -2003 error as well?

Created on Aug 26, 2016 12:26:39 PM by Arne Seifert [Paessler Support]

Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.