Can prtg send snmp trap for cisco switch port-security violation?
is each switch port consider a sensor?
Thank you,
cisco switch port-security violation snmp trap
Votes:
0
1 Reply
Votes:
0
Hello,
When you're monitoring a device with a Trap Receiver sensor it is that device that needs to send traps and PRTG will capture/display them.
The Trap Receiver sensor works a bit differently than other sensors in PRTG, you can aggregate multiple messages from a same device or even from multiple devices in a single sensor, in this case the "sensors per device" rule doesn't apply.
Please find out more about this approach here.
Best Regards, Luciano Lingnau [Paessler Support]
Created on Sep 12, 2016 10:39:16 AM by
Last change on Feb 28, 2023 3:01:04 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment