The monitoring computer has multiple IPv4 addresses as it is monitoring networks which are not routed. In some networks, the computer has multiple IPv4 addresses, so the default source address may not be correct.
Is there a way of specifying the source IPv4 address for outbound SNMP connections on a sensor rathe
Votes:
0
1 Reply
Accepted Answer
Votes:
0
Hello,
I'm afraid in the moment it's not possible to specify the IP for outgoing SNMP requests.
Best Regards.
Created on Jul 26, 2010 2:27:20 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment