What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

How can I customize PRTG report?

Votes:

0

I need customize PRTG report, file <Table only> on following link webroot\reporttemplates\details to display sensor ID in the table:

Now: Probe, Group, Device: Local probe > CHANNELS_UTILIZATION > Device ID

Need: Probe, Group, Device, Sensor ID: Local probe > CHANNELS_UTILIZATION > Device ID > Sensor ID

customize prtg reports

Created on Nov 21, 2016 9:39:45 AM



2 Replies

Accepted Answer

Votes:

0

Dear dcme

That is not supported for reports. In principle, you can use #objectstatus id="<@objectid>" name="objid" as a placeholder to resolve to the sensor ID. However, it will be difficult to get this into the table while still looking nice, and since the reports are for sensors, you have to good way to get the according device ID.

A better solution might be to read out devices and sensors via the PRTG API.

Created on Nov 21, 2016 4:34:26 PM by Arne Seifert [Paessler Support]



Votes:

0

Thank you so much!!! Working fine.

Created on Nov 22, 2016 4:54:05 AM




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.