What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Speed

Votes:

1

I monitor or Ping my ubiquiti access point through PRTG. It was very help ful, because i`m able to ping my all AP through single interface.

But is there any sensor for measuring the speed, like how much bandwidth this IP or Ap consumption. so i know which ap is in maximum load mode.

bandwidth-speed current-speed link-speed prtg-network-monitor

Created on Dec 13, 2016 12:18:19 PM



1 Reply

Votes:

0

Hi there,

Perhaps the APs offer monitoring via SNMP? If so, please enable and configure it properly and add the configured details to the group/device settings within PRTG. Afterwards add the "SNMP Traffic" sensor and check if you get any result. This way you can monitor the network interfaces of the Access Points directly and see their current utilization.

Created on Dec 13, 2016 10:19:40 PM by Dariusz Gorka [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.