What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

SNMP Cisco RV180

Votes:

0

Bonjour,

Je voudrais savoir si il est possible sur PRTG Network monitor de superviser un routeur cisco rv180 à distance en SNMP v2.

Merci d'avance.

-----------------------------------------------------------------------------------------------------

Hello

I would like to know if it is possible on PRTG Network monitor to oversee a cisco rv180 remotely in SNMP v2 router.

Thanks in advance.

cisco probe prtg snmp snmp-sensor snmp-traffic

Created on Feb 13, 2017 1:30:04 PM



1 Reply

Votes:

0

Hello,
thank you for your KB-Post.

I've just checked the Router's Datasheet:

The following Management alternatives are available:

Management ProtocolsWeb browser, Simple Network Management Protocol (SNMP) v3, Bonjour, Universal Plug and Play (UPnP)

I've highlighted the SNMP protocol because this is the "mainly" spoken protocol by PRTG. Please refer to the following manual page for an introduction to SNMP:

Basically, configure SNMP on your device, make sure that it answers to ping an run an Auto-Discovery. PRTG will deploy all standard compatible sensors automatically.

Best Regards,
Luciano Lingnau [Paessler Support]

Created on Feb 16, 2017 8:08:06 AM by Luciano Lingnau [Paessler]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.