What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

SNMP Custom Table Sensor 17.1.30

Votes:

0

Isn't it possible to define SNMP Custom Table Sensors in the current version? I can't find any entries concerning this sensor.

prgt snmp snmp-custom-table

Created on Apr 29, 2017 8:13:31 AM



3 Replies

Votes:

0

Hello,

Thank you for the KB-Post. Which exact errors do you get? Please send some screenshots showing the exact error messages from the "Overview"-Tab. In case the sensors are not in error-state right now, you can also check the "Log" tab of the sensor, to view previous error-messages.

best regards.

Created on May 1, 2017 9:57:45 AM by Torsten Lindner [Paessler Support]



Votes:

0

The code is PE248 - The OID doesn't point to a table. But in the MIB importer the OID is marked as table...

Created on May 2, 2017 4:16:20 AM



Votes:

0

There was an issue with the SNMP Table Sensor in Version 17.1.30.1681. If you have a newer version, it's fine, if not, please update.
If the OID isn't really a table, try adding it manually into a normal SNMP Custom Sensor then.

Created on May 2, 2017 8:37:52 AM by Torsten Lindner [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.