What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

SFlow problems with HP Procurve 2810

Votes:

0

Hey Guys, I have some problems getting sflow to work on a HP Procurve 2810. I think my configuration on the Switch is just fine. Sflow is enabled and sending Datagrams. But PRTG is not recieving any data. The sensor is stuck in "grey" mode. All other sensors (not sflow) are just working fine. Any thoughts what could be wrong?

procurve sensor sflow

Created on Jun 30, 2017 6:12:28 AM



1 Reply

Votes:

0

Dear PeterKnasalla

In this case, please manually pause the Sflow sensor. Then please run the Sflow tester. Enter the device address / port and start the test. Do you get any flows there?

Created on Jul 3, 2017 1:38:56 PM by Arne Seifert [Paessler Support]

Last change on Jul 3, 2017 1:39:05 PM by Arne Seifert [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.