we can not implement sensors for IPSEC tunnels on cisco routers , only firewalls are allowed . we need to add sensors for IPSLA & traffic utilization . your feedback whether its doable or not.
how to monitor site-to-site IPSEC tunnel on Cisco 1941/K9
Votes:
0
1 Reply
Votes:
0
Hello Ahmed,
Thank you very much for your kb post. Did you already tried to deploy one of the Cisco ASA VPN sensors? Even though they are not especially stated for Cisco routers, however it might be possible that the used OID's in this sensor are not exclusively for ASA firewalls.
Does this work?
Best regards,
Sebastian
Created on Jul 21, 2017 12:17:52 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment