What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Is it possible to create a trigger who sends a message if a sensor goes to ok?

Votes:

0

For rollouts or installations it would be fine to import a list and get a message if an triggger goes to status "ok"

message ok-trigger sensor

Created on Nov 24, 2017 12:00:03 PM



1 Reply

Votes:

0

Hi Robert,

The state trigger allows you to set a When condition clears after a notification was triggered perform no notification condition for sensors which show an up status after the initial event. This allows you to configure an according event to get notified. The Up Condition cannot be used in the default triggers except for this "condition clear" event

Best regards, Felix

Created on Nov 27, 2017 6:35:22 PM by Felix Saure [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.