Hi I'm trying to create a way to monitor bandwidth inside our network, I've got an edgerouter, i've enabled Netflow, downloaded and configured the sensor. I'm getting all the destination ip addresses as 192.168.2.2, which is the WAN's internal ip address. can you let me know where i can continue looking? I've done all the searching I can think to look for.
Help-a-noob Netflow host IP not showing internal ip.
Votes:
0
1 Reply
Votes:
0
The toplist channels do have a reverse DNS setting (visible when you click the small channel gear). Did you disable/enable that one already to see if that does the trick (although I doubt it)?
Kind regards,
Stephan Linke, Tech Support Team
Created on Dec 5, 2017 2:51:30 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment