I have set the Netflow udp port 9995 on ASA via ASDM, and created the new Netflow V9 sensor, and define the same port, Sender IP is ASA, active flow timeout 10mins, samling rate is 1 min as the same settings on ASA. But this sensor always shows grey "unknown". I closed the whole windows local firewall, but it still doesn't work. Any suggestions ? Thanks !
Netflow V9 doesn't work
Votes:
0
1 Reply
Votes:
0
Hi there,
In order to find out if proper and compatible Netflow packets are arriving at the PRTG host, please use our Netflow Tester:
https://www.paessler.com/tools/netflowtester
Please post a screenshot from the Netflow Tester here so we can analyze this further.
Best regards.
Created on Dec 14, 2017 12:42:46 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment