What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

I have created a partial selection of a MIB. Doesnt load properly.

Votes:

0

I have created a partial selection of a MIB. When I Save it for PRTG Monitor all seems ok. When I go into PRTG and try to add a sensor using the Part MIB about half of the info is missing...??

At no time did I get any error messages. :-(

Any thoughts....?

mib prtg snmp

Created on Dec 14, 2017 12:32:18 PM



1 Reply

Votes:

0

Hi there,

What do you mean by "Half of the info is missing"? Do you wonder why not all data that was listed in the OID-Lib is listed during the creation of the SNMP Library Sensor?
If so, then it is most likely the case the the device does not offer data for all OIDs in the OIDlib.

Best regards.

Created on Dec 15, 2017 9:52:32 AM by Dariusz Gorka [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.