Hi Team,
Is it possible to change the error status to error only instead of down status when threshold value is above the error limits for a selected sensors in the PRTG Tool.
Is it possible to change the error status to error only instead of down status when threshold value
1 Reply
Hello there,
When setting a limit in a sensor's channel, this will always impact the status of a sensor, this cannot be avoided or delayed. If you want to receive a notification, when a certain threshold is met without changing the sensor's state, disable the limit in the sensor's channel and create instead a threshold trigger in the sensor's "Notifications" tab.
Kind regards,
Erhard
Created on Feb 6, 2018 12:44:41 PM by
Please log in or register to enter your reply.
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment