I want to be able to receive alerts if ports certain ports on a switch are set at 100Mbps
1 Reply
Accepted Answer
Votes:
0
Hello there,
we appreciate your contact.
This can be done with our SNMP Custom Table sensor, please have a look at this guide:
There are two OID's from two different Tables you could use, check what's available on your device:
- ifSpeed from ifTable (1.3.6.1.2.1.2.2)
- ifHighSpeed from ifXTable (1.3.6.1.2.1.31.1.1)
You can deploy the sensor and use lookups or limits to alert whenever the corresponding value represents 100 mbps or less. You could also deploy the sensor once and create a device template, so that you can apply this sensor to any number of devices automatically.
Best Regards,
Luciano Lingnau [Paessler Support]
Created on Mar 23, 2018 1:27:33 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment