What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
300.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

How to change color of Lower Warning Limit to something different than Upper Error Limit and Upper W

Votes:

0

Your Vote:

Up

Down

For our sensors, we would like to have different color for Upper Error Limit, Upper Warning Limit and Lower Warning limit. Currently what i notice is that the color for Upper warning limit and lower warning limit is the same (Yellow). I want to change the color for Lower Warning limit only to Grey for example. Can someone help with this?

prtg snmp throughput

Created on Mar 28, 2018 5:25:27 PM by  boris (0) 1



1 Reply

Votes:

0

Your Vote:

Up

Down

Hello boris,

Thank you very much for your contact.

Unfortunately, it is not possible to change the color code of the warning or error state. Besides that fact please note that the lower and upper warning equally define the range in which a sensors turns into warning, so both define basically the same sensor state.

Lower Warning Limit (%): Values below this limit will set the sensor to warning.
Upper Warning Limit (%): Values above this limit will set the sensor to warning.

Best regards,
Sebastian

Created on Mar 28, 2018 6:24:14 PM by  Sebastian Kniege [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.