What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

is it possible to acknowledge an alarm UNTIL it comes back up and if it goes down again it requires

Votes:

0

is it possible to acknowledge an alarm UNTIL it comes back up and if it goes down again it requires re-acknowledgement?

acknowledgement alarms prtg

Created on May 31, 2018 11:32:53 PM



1 Reply

Votes:

0

Hello,

You can setup a State Trigger then when the sensor comes back from a down event, it will kick off a Notification.

This notification can include an API call to your PRTG server itself to resume the sensor.

The API call to make this happen would be the following

<YOUR PRTG URL>/api/pause.htm?id=%objid&action=1

This will cause the sensor that evokes the notification to make an API call to resume itself.

Thanks!

Benjamin Day
[Paessler Support]

Created on Jun 1, 2018 12:48:41 AM by Benjamin Day [Paessler Support] (1,441) ●2 ●1




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.