I would like to use a proxy with the HTTP Full Web Page sensor. Where can I find the proxy settings?
Created on Sep 17, 2018 10:36:50 AM by
Last change on Dec 10, 2020 10:07:22 AM by
1 Reply
Accepted Answer
This article applies to PRTG Network Monitor 19 or later
Using a proxy with the HTTP Full Web Page sensor
The HTTP Full Web Page Sensor uses a browser engine to measure the loading time of a web page.
For all browser engines, the same proxy settings are used that are configured for the Windows user account that the PRTG probe is running on. This is usually the Windows local "system" user account, if you did not change it. To use a proxy to measure the loading time of a web page, you need to adjust the proxy settings accordingly.
The proxy settings are accessible using one of the following methods, for example:
Internet Explorer
To access the proxy settings in Internet Explorer, follow these steps.
- Open Tools in the menu bar. You can also use the shortcut Alt+X.
- Select Internet options.
- Go to the Connections tab.
- Under Local Area Network (LAN) settings, click the LAN settings button.
Control Panel
Alternatively, you can also access the proxy settings using the Control Panel.
- From the Windows start menu, open the Control Panel.
- Click Network and Internet.
- Click Internet Options.
- Go to the Connections tab.
- Under Local Area Network (LAN) settings, click the LAN settings button.
Created on Sep 17, 2018 12:03:04 PM by
Last change on Dec 10, 2020 10:07:33 AM by
Please log in or register to enter your reply.
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment