What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Notification Summarization problem

Votes:

0

hello anyone can help me? in Notification Summarization method i choose >> Send first DOWN and UP message ASAP, then summarize time 60 minute if one device sensors turn off, then prtg send me first down message,then he begins collect information during 60 minute and send one report message. but i can't see during 60 minutes if other important device or sensor turn off ,only report show me ..

what is right method to choose? i dont want to get one sensors errors every minutes...

prtg sensor summarization

Created on Nov 30, 2018 6:36:48 AM



4 Replies

Votes:

0

Hello there,

Then I would suggest to set Send all DOWN messages ASAP, summarize the others, this will send a notification for each sensor that enters "down" state or use a shorter summary period otherwise.

Kind regards,

Erhard

Created on Nov 30, 2018 12:54:52 PM by Erhard Mikulik [Paessler Support]



Votes:

0

dont work. i simulated error status one devices sensor and i get error in mail its ok then i simulated another devices sensor and get erro in mail its ok . i want get massage if other sensors died in 60 minute.its fine but then turn on both devices sensors and agian simulated and turn off . and get massage agian.i dont want tu get(died) massage again same devices sensors during 60 minutes.

Created on Nov 30, 2018 1:23:37 PM



Votes:

0

anyone can help me ?

Created on Dec 3, 2018 7:22:45 AM



Votes:

0

I'm not sure I fully understand what you mean, maybe there is a misunderstanding how summarization works:
Send first DOWN and UP message ASAP, then summarize:
When receiving several DOWN or UP triggers, send each first notification immediately, then keep summarizing notification triggers into one message, regardless of sensor status.

Also check how those triggers are configured. If you set it simulated error for only a few seconds, but the state trigger is set to like "When sensor is down for 60 seconds", the trigger won't get activated.

In case "Send all DOWN and UP messages ASAP, summarize the others" does not do what you expect, then please contact us by email ([email protected]) and send us additional details, especially screenshots from the sensors you tested this with (tabs "Log" & "Notification Triggers" and from the notification templates as well)

Kind regards,

Erhard

Created on Dec 3, 2018 9:28:58 AM by Erhard Mikulik [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.