New Question
 
 
PRTG Network Monitor

Intuitive to Use.
Easy to manage.

200.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free PRTG
Download >>

 

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

 

Top Tags


View all Tags


UCS Physical Disk Monitor

Votes:

0

Your Vote:

Up

Down

Hi,

I am trying to monitor the UCS Physical Disk, and I get the following error "Could not find any matching data on this device. (code: PE187)"

I downloader the SNMP Tester on the probe where I want to set the sensor. I set SNMP settings properly and select Walk as request type. I run a walk on with the followed OID 1.3.6.1.2.1.25.2.3.1. and checked the value:

"Error # -2003"

disk error oid snmp snmp-tester ucs

Created on Jan 15, 2019 11:48:11 AM by  mgaya (0) 1



1 Reply

Votes:

0

Your Vote:

Up

Down

Hello,

Thank you for the KB-Post. Do you have other SNMP based sensors working fine on the same device in PRTG?

1.3.6.1.2.1.25.2.3.1 is actually another table and not used for the UCS Sensors at all. Do other UCS Sensors work on this device?

best regards.

Created on Jan 16, 2019 9:00:25 AM by  Torsten Lindner [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.