New Question
 
 
PRTG Network Monitor

Intuitive to Use.
Easy to manage.

200.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free PRTG
Download >>

 

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

 

Top Tags


View all Tags


How to search sensors with a specific error code?

Votes:

0

Your Vote:

Up

Down

Hello,

I've got a PRTG installation with more than 10.000 snmp traffic sensors on switches, and i've setted up all the uplink interfaces to "Show alarm when disconnected, but ignore when deactivated".

When an interface get deactivated the sensor stay up with the message "OK. The interface has been deactivated. ifAdminStatus=down (2) (code: PE059)", is there a way to rapid search all of the sensors with code:PE059 to monitor wich critical interfaces have been administratively deactivated?

thank you, Enrico

network pe-code snmptrafficsensor

Created on Feb 22, 2019 6:48:11 PM by  Enpo (0) 1



2 Replies

Accepted Answer

Votes:

1

Your Vote:

Up

Down

Hi there,

Please head to "Sensors > By Type > S.. > SNMP Traffic" and add the following to the URL:

&[email protected](PE059)

This should filter for all sensors with the message that has "PE059" in it.

Best regards.

Created on Feb 25, 2019 12:03:38 PM by  Dariusz Gorka [Paessler Support]



Votes:

0

Your Vote:

Up

Down

Thank you! The line provided works perfectly

e.

Created on Feb 25, 2019 3:17:01 PM by  Enpo (0) 1



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.