What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

PRTG SHARPS

Votes:

0

Good day! I have issue with in PRTG. In image below you can see sharps, and after reboot PRTG sharps disappear but come back again. It is randomly from different devices. (Cisco) Sometimes appear and disappear. I have checked real load interfaces it is without sharps https://ibb.co/dtXqfQ3

graphs prtg sensor

Created on Mar 5, 2019 3:14:34 AM

Last change on Mar 5, 2019 9:43:47 AM by Torsten Lindner [Paessler Support]



2 Replies

Votes:

0

Hi there,

Could you check if this is the 32Bit or 64Bit SNMP Traffic Sensor? I assume that you run into the issue explained here:
https://kb.paessler.com/en/topic/43503-what-is-the-overflow-values-setting-in-the-snmp-compatibility-options

Best regards

Created on Mar 5, 2019 11:11:00 AM by Dariusz Gorka [Paessler Support]



Votes:

0

Both devices configured as 64Bit SNMP
for test i change on one device from " Handle overflow values as valid results" to "Ignore overflow values"
But issue save on both devices.
Both use snmp v2c
There are any ideas?

https://ibb.co/XCzPw6K
https://ibb.co/m6769j2

Created on Mar 6, 2019 11:32:37 AM

Last change on Mar 6, 2019 12:01:37 PM by Dariusz Gorka [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.