New Question
 
 
PRTG Network Monitor

Intuitive to Use.
Easy to manage.

200.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free PRTG
Download >>

 

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

 

Top Tags


View all Tags


New notification aboub Probe status.

Votes:

0

Your Vote:

Up

Down

Hello!

I need to create Notification, which will be sended if one (selected) Probe will be offline. I confused a little, because as far as i understand i need to create this Notification on Root level, but this notification will work for all Probes (and sesnors). How i can create this Notification only for one Probe?

notification offline probe

Created on Apr 19, 2019 9:33:25 AM by  Vasiliy (42) 1



3 Replies

Votes:

0

Your Vote:

Up

Down

Hello Vasiliy,

thank you for the KB-Post. You would achieve such a notification by putting the trigger on the Probe Health Sensor of this very Remote Probe. The Probe Health Sensor will go into error state if the according Probe is disconnected, and so send you a notification about this.

best regards.

Created on Apr 19, 2019 11:55:24 AM by  Torsten Lindner [Paessler Support]



Votes:

0

Your Vote:

Up

Down

Yep, this working, with latency but working. Another question - i made Notification only for Down state and leave Down state, but PRTG send me notification about Unknown state after Down (for some sensors from Disconnected Probe). Can i avoid this and get only UP and DOWN?

Created on Apr 19, 2019 12:40:19 PM by  Vasiliy (42) 1



Votes:

0

Your Vote:

Up

Down

You could try working with a specific trigger that works with the condition of the sensor being un UP state, but this would then also trigger if the sensor comes from warning for example. So, only workarounds are possible here, which will have drawbacks too.

Created on Apr 19, 2019 12:55:50 PM by  Torsten Lindner [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.