New Question
 

Back to www.paessler.com

 
PRTG Network Monitor

Intuitive to Use.
Easy to manage.

200.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free PRTG
Download >>
 

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

 

Top Tags


View all Tags


Change Sensor Connection Status Handling in Group

Votes:

0

Your Vote:

Up

Down

hi dear i have a lot of sensors that i want to Changing their Connection Status Handling of "show alarm for all disconnecred states" to Ignore all disconnected states in their setting can i do it

kind regard somaye

alarm connection status

Created on May 12, 2019 7:40:36 AM by SJB (0) ●2



2 Replies

Accepted Answer

Votes:

0

Your Vote:

Up

Down

Hi there,

This can be done by following these steps:

  1. navigate to "Sensors > By Type > S.. > SNMP Traffic"
  2. click the maximum number in the upper right side of the table to display all sensors
  3. mark all sensors via the checkbox on the right side
  4. click on the wrench-icon on the right side and change the "Connection Status Handling" to your needs.

    Please also see:
    https://www.paessler.com/manuals/prtg/multi_edit_lists

    Best regards.

Created on May 13, 2019 8:48:34 AM by Dariusz Gorka [Paessler Support]

Last change on May 13, 2019 8:48:49 AM by Dariusz Gorka [Paessler Support]



Votes:

0

Your Vote:

Up

Down

hi there thanks a lot for your guidance best regard

Created on May 13, 2019 1:01:12 PM by SJB (0) ●2



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.