What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

separating traffic ipv4 and ipv6 in an interface

Votes:

0

hi there how to i can separating traffic ipv4 and ipv6 in an interface? thank you beforehand for your guidance kind regard somaye

ipv4 ipv6 traffic

Created on May 18, 2019 10:47:20 AM



5 Replies

Votes:

0

Hi there,

You can create new channels in the Packet Sniffer Sensor or any flow sensor, you can find the require syntax in this article. Filtering for the EtherType can separate IPv4 from IPv6.


Kind regards,
Felix Saure, Tech Support Team

Created on May 20, 2019 10:36:23 AM by  Felix Saure [Paessler Support]

Last change on Dec 2, 2021 9:28:57 AM by  Maike Guba [Paessler Support] (2,404) 2 1



Votes:

0

hi there I have a senor as follows: Vl1149 - IXP-Irancell-v6-v4 that monitor the v4 and v6 traffics how can i separate traffic of v4 and v6 in prtg? thank you best regard

Created on May 26, 2019 7:06:56 AM

Last change on May 26, 2019 7:06:56 AM



Votes:

0

Hi there,

What sensor type are you using, the SNMP Traffic Sensor by any chance? This sensor type cannot separate v4 from v6 traffic, the information is not available via SNMP. Just the total bandwidth on that interface is displayed. If you want to divide that traffic, you need to go for a flow sensor or packet sniffer sensor instead with the filters named in my first reply.


Kind regards,
Felix Saure, Tech Support Team

Created on May 27, 2019 6:56:49 AM by  Felix Saure [Paessler Support]

Last change on Dec 2, 2021 10:12:25 AM by  Maike Guba [Paessler Support] (2,404) 2 1



Votes:

0

hi there i created a flow sensor and enter the ipv6 but the sensor gave an error because ipv6 was invalid in sensor! kind regards somaye

Created on May 28, 2019 5:18:14 AM

Last change on Dec 2, 2021 10:13:32 AM by  Maike Guba [Paessler Support] (2,404) 2 1



Votes:

0

How exactly did you enter the filter rule? Could you please provide a screenshot of the complete sensor's settings page?


Kind regards,
Felix Saure, Tech Support Team

Created on May 28, 2019 5:55:59 AM by  Felix Saure [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.