New Question
 
 
PRTG Network Monitor

Intuitive to Use.
Easy to manage.

200.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free PRTG
Download >>

 

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

 

Top Tags


View all Tags


alert as per CPU Limit

Votes:

0

Your Vote:

Up

Down

How to set CPU high utilization limit.

cpu-load cpu-utilization snmp

Created on Jul 4, 2019 4:52:14 AM by  admin (0) 1



1 Reply

Votes:

0

Your Vote:

Up

Down

Hello,

You are able to set a Warning or a Limit on a sensors by configuring the Warning-/Error-Limits on those sensors, so that they change their state into Warning or Error state if a certain value/limit is reached. You can set such Limits on the Channel-Tab of most sensors.

Disk, CPU and Memory sensors actually already have these limits pre-set by default, so the sensors will already go into Warning-/Error-State if certain limits are reached (you can of course check the limits or change them), and then all you need is an appropriate State Trigger notification on those sensors in order to get an alert when the error happens.

Regards.

Created on Jul 5, 2019 8:38:37 AM by  Jonathan Mena [Paessler Technical Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.