What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

exclusion of devices when running a filter of alarms

Votes:

0

Good Day,

I run a list of alarms for our Service desk environment just to show all down devices at that current moment, i have a group that i would like to be excluded from this list however i am unsure of how to just exclude the specific group so below is my URL:

https://myserver.mydomain.com/sensors.htm?id=0&filter_status=5&columns=priority,downtimesince,probe,device,status,sensor,message

i would like to exclude the group 35396 (this is the root of a remote probe), anybody know if this is actually possible.

B,

filter prtg url

Created on Aug 16, 2019 11:29:37 AM



2 Replies

Accepted Answer

Votes:

0

Hi there,

By default this is not possible, but you could use a tag to do this. Therefore, please follow these steps:

  1. Add a tag to the corresponding Object (Group, Device, Sensor). E.g.: exclude
  2. Create a filter with this tag: 
https://myserver.mydomain.com/sensors.htm?id=0&filter_status=5&columns=priority,downtimesince,probe,device,status,sensor,message&filter_tags=@tag(-exclude)

Kind regards,
Birk Guttmann, Tech Support Team

Created on Aug 16, 2019 1:46:39 PM by Birk Guttmann [Paessler Support]



Votes:

0

I guess if that's the only route i will do that :)

Thanks,

Created on Aug 19, 2019 4:10:39 AM




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.