Is there a way so that PRTG starts to pause automatic Sensors on a specific Time?
Pause Sensors automatic
Votes:
0
1 Reply
Votes:
0
Hello MatzeK,
thanks for your KB porting.
Please find all relevant information regarding schedules under the links below:
- https://www.paessler.com/manuals/prtg/scheduling
- https://www.paessler.com/manuals/prtg/schedules_settings
There are two primary use cases for schedules:
- The usage on notifications - here the schedules are entered in the settings of the notification templates. The notification is then paused at the defined times, but the monitoring itself remains active.
- The usage on probes/groups/devices - in this case the complete monitoring, i.e. the respective subordinated sensors, is paused during the specified time. The notifications remain active, but do not send anything, since no errors occur in the pause state.
Best regards,
Sven Roggenhofer [Paessler Technical Support]
Created on May 15, 2020 4:52:36 AM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment