What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Commands used in SSH sensors

Votes:

0

I would like to know the specific commands used for:
SSH load average
SSH meminfo
SSH INodes Free

The reason is I need to know the permissions required in the target device to execute these sensors before I can ask for a user, so I can not use history command to obtain them.

Thanks and kind regards

prtg sensors ssh

Created on May 28, 2020 9:45:07 AM

Last change on May 28, 2020 3:21:27 PM by Birk Guttmann [Paessler Support]



1 Reply

Votes:

1

Hi there,

We do not share our specific commands we use to query data, since this is internal knowledge. Please configure a user that is allowed to run the sudo commands and reach the usual performance parameters.

Kind regards,
Birk Guttmann, Tech Support Team

Created on May 28, 2020 3:25:54 PM by Birk Guttmann [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.