What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

I need to apply a Filter in SNMP Trap Reciever

Votes:

0

A device sends me the following trap:

	SNMPv2-MIB::snmpTrapOID.0 = AcBoard::acIpGroupNoRouteAlarm
AcBoard::acBoardTrapGlobalsName.0 = 113
AcBoard::acBoardTrapGlobalsTextualDescription.0 = IP Group is temporarily blocked. IPGroup(Default_IPG) Blocked Reason: Keepalive
AcBoard::acBoardTrapGlobalsSource.0 = Board#1/IPGroup#0
AcBoard::acBoardTrapGlobalsSeverity.0 = major (4)
AcBoard::acBoardTrapGlobalsUniqID.0 = 35
AcBoard::acBoardTrapGlobalsType.0 = qualityOfServiceAlarm (2)
AcBoard::acBoardTrapGlobalsProbableCause.0 = thresholdCrossed (51)
AcBoard::acBoardTrapGlobalsAdditionalInfo1.0 =
AcBoard::acBoardTrapGlobalsAdditionalInfo2.0 =
AcBoard::acBoardTrapGlobalsAdditionalInfo3.0 =
AcBoard::acBoardTrapGlobalsDateAndTime.0 = 07E4081210351600
AcBoard::acBoardTrapGlobalsSystemSeverity.0 = critical (5)
AcBoard::acBoardTrapGlobalsDeviceName.0 = 0
AcBoard::acBoardTrapGlobalsDeviceInfo.0 = 0
AcBoard::acBoardTrapGlobalsDeviceDescriprion.0 = 0
AcBoard::acBoardTrapGlobalsSystemSerialNumber.0 = 11298585

I need the filter to recognize a part of the message, for example (IP Group is temporarily blocked) and thus be able to generate a failure.

Saludos

audiocodes- prtg snmp

Created on Aug 18, 2020 7:25:01 PM

Last change on Aug 19, 2020 9:10:30 AM by  Moritz Heller [Paessler Support]



3 Replies

Votes:

0

Hi there,

I would recommend to check the trap received in PRTG and then configure a filter rule according to this article: https://www.paessler.com/manuals/prtg/snmp_trap_receiver_sensor#filter_rules

Created on Aug 19, 2020 9:11:38 AM by  Moritz Heller [Paessler Support]



Votes:

0

Hi Moritz,

I have read the manual, but I can't get the sensor to detect the message, try several filters, example:

bindings[SNMPv2-MIB::snmpTrapOID.0 = AcBoard::acIpGroupNoRouteAlarm] bindings[AcBoard::acBoardTrapGlobalsTextualDescription.0 = IP Group is temporarily blocked.] bindings[IP Group is temporarily blocked.]

Thanks

Created on Aug 19, 2020 1:22:58 PM



Votes:

0

Problem solved

Thanks

Created on Aug 19, 2020 6:48:14 PM




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.