New Question

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Sensor wmiutctimesensor

Votes:

0

Your Vote:

Up

Down

Good Morning,

i am asking myself when this sensor will switch to "error"? Or is this just a monitor?

Kind regards Tappsy

prtg utc wmi

Created on Sep 16, 2020 6:35:48 AM by Tappsy (0) ●1



1 Reply

Votes:

0

Your Vote:

Up

Down

Hello,

Thank you for your message.

By default, the WMI UTC Time sensor goes into Error state only when something occurs during the execution of the WMI request to the target device.

However, like with the other sensors you can configure channel limits. For example, with this sensor you can configure alerts when the value in the channel "Difference" is higher than a defined time (in seconds).

Kind regards.

Created on Sep 16, 2020 7:47:01 AM by Florian Lesage [Paessler Support]

Last change on Sep 16, 2020 7:47:15 AM by Florian Lesage [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.