What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Sub interfaces is not adding on Cisco Routers ASR 1000

Votes:

0

I am trying to add sub-interface on cisco routers , but not able to do successfully. I did change couters 32 bit and again added it but no success. Please advice

cisco-router prtg subinterface

Created on Dec 21, 2020 8:59:44 AM



3 Replies

Votes:

0

Hi,

can you please let me know which sensor you try to add? Were you able to add the sensor for the primary (non-sub) interfaces?

Kind regards,
Matthias Kupfer - Team Tech Support

Created on Dec 24, 2020 3:50:19 PM by Matthias Kupfer [Paessler Support]



Votes:

0

HI Team,

Please find below screenshot , Its physical Te0/1/1 , sub interfaces are already there. We recently created new sub interface Te0/1/1.206 , which is not able to add and monitor

Created on Dec 24, 2020 3:57:39 PM



Votes:

0

Hi,

unfortunately I am missing your mentioned screenshot. Can you please post it again.

We can also handle this in a support-ticket, which might be easier to exchange logs and screenshots. If you want to do so, please write a email to support@paessler and refer to this KB article.

Kind regards, Matthias Kupfer - Team Tech Support

Created on Dec 28, 2020 8:06:42 AM by Matthias Kupfer [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.