What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags

View all Tags

Means to monitor traffic on Unifi Dream Machine Pro (UDM-PRO)



Firmware Version: 1.8.5 Release Date: 29/12/2020 UI: Backend: 6.0.43 Buildatag_6.0.43_14348

Is there any way to monitor the Unifi Dream Machine Pro via a PRTG sensor? So far I can only access uptime via SNMP which had to be manually installed via SSH. The interfaces are not available via SNMP and when performing an autodiscovery the the basic sensors Ping, HTTPS, SSL Certificate Sensor (Port 443), SSL Security Check (Port 433) and Uptime (via my SNMP) are created but nothing else.

Enabling SSH creates some additional sensors: SSH Disk Free, SSH INodes FREE, SSH Load Average and SSH Meminfo but these are not connected to the interfaces.

prtg sensor snmp-traffic unfi

Created on Jan 20, 2021 11:41:44 AM

1 Reply




Thank you for your KB-post.

If SNMP is supported by this device, could you please try manually adding an "SNMP Traffic Sensor"? Does that work?

Beside that, you can also check SNMP response using our SNMP Tester: https://www.paessler.com/tools/snmptester

Created on Jan 21, 2021 10:29:25 PM by  Isidora Jeremic [Paessler Support]

Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.