I've looked around quite a bit and I can't seem to figure out how to remove a Sensor from a Library so the Sensor doesn't inherit the Library's Notification settings.
How do you remove a Sensor from a Library?
Votes:
0
1 Reply
Votes:
0
Hello,
this would depend how the sensor was added. In case a tag filter is used, please remove the respective tag from the sensor.
If that tag is inherited to the sensor, it cannot be removed though. Also if sensor-type filtering is used, or larger nodes like devices or device groups were added as library node, a single sensor cannot be removed. Instead, the whole library node has to be removed and added anew in a way that the sensor in question is not part of it.
Created on Jul 20, 2022 9:16:05 AM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment