What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

SNMP Sensor - How to configure for smoke detector output

Votes:

0

Hi All, I've been using PRTG for some time to monitor values from SNMP or other devices, works great. However I need to monitor some smoke detectors connected to an APC NetBotz appliance via SNMP v3.

It's all configured and I've used the SNMP Custom sensor to monitor the specific OIDs from the NetBotz. A value of 1 means the sensor is in smoke state, so has been triggered. A value of 2 means it is OK - No smoke detected.

Rather than showing the needle/performance style indicator, is it possible to show a green panel for OK (e.g. value is 2) or a red panel (e.g. value is 1) for smoke state somehow?

netbotz smoke-dtector snmp

Created on Aug 31, 2022 3:34:51 PM



1 Reply

Votes:

0

Halo Richard,

You can use a lookup for that, more information about them can be found here:

https://www.paessler.com/manuals/prtg/define_lookups


Kind regards,
Leong, Tech Support Team

Created on Sep 6, 2022 6:28:06 AM by  Leong

Last change on Jan 19, 2023 4:47:23 PM by  Leong




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.